Console (DSM) (CPM)(SRM) V6.59 (Date Code Mon Feb 10 10:41:10PST 2020) 1. OpenSSL: 1.0.2t-fips 10 Sep 2019 2. Openssh: 8.0p1 3. Apache httpd: 2.4.39 4. RESTful Versions: v1.0, v2 (Jan19) 5. LCP strings added to Cell PPP connection test. If PPP connection is not detected, code will restart PPP connection sequence. Obtaining Firmware Updates: The most recent updates for our Console Server Products, Switched PDU Products and Data Fallback Switch products can be by filling out the firmware request form that can be found at the following page on the WTI website: http://www.wti.com/t-firmware-upgrade.aspx Release notes for our most recent firmware updates are listed below. For older firmware updates, please contact WTI Tech Support at service@wti.com or call our toll free service line at 1-888-280-7227. Customer Service Department hours are 8 AM through 5 PM, Pacific Daylight Time. Installation: The WMU Enterprise Management Software, which is included with WTI Devices, is the preferred method for installing firmware updates on WTI devices. The WMU software allows you to manage firmware updates for multiple WTI units from a single interface. For a description of the process for managing firmware updates via the WMU, please refer to the WMU user's guide, which can be downloaded from the WTI User's Guide Archive at: http://www.wti.com/t-product-manuals.aspx Note that in order to use the WMU software, the existing firmware version for the WTI Device(s) must conform to the following standards: • Console Server Products (DSM Series, TSM Series and RSM Series): Firmware Version v6.23 or higher. • Switched PDU Products (VMR Series, NBB Series, NPS Series, RPC Series, CMM Series): Firmware Version 1.48 or higher. • Data Fallback Switch Products (AFS Series): Firmware Version 2.30 When upgrading older units that are running firmware versions that are earlier than the standards listed above, it is recommended to use the WTI Firmware Upgrade Utility. A zip file that contains the installation files and other documentation for the WTI Firmware Upgrade Utility can be downloaded from WTI's FTP server, located at: ftp://wtiftp.wti.com/pub/TechSupport/Firmware/Upgrade_Utility/ Please refer to the documentation included in the zip file for further instructions. In addition to the WMU and WTI Firmware Upgrade Utility, the /UF command can also be used to install firmware upgrades. For more information on the /UF command, please refer to the user’s guide for your WTI device.