ARM Power V3.03 (Date Code: Wed Dec 21 11:34:17 PST 2022) 1. OpenSSL: 1.0.2u-fips 20 Dec 2019 2. OpenSSH: 8.8p1 3. Apache: 2.4.49 4. IPSec: 5.9.3/K5.4.0 5. OpenVPN: 2.5.3 6. bash: 5.0.0(1)-release 7. RESTful: v1.0, v2 (Jan22) 8. IPSec Version: 5.9.4/K5.4.0 9. NET-SNMP Version: 5.9.1 10. Invalid Access Lockout’s Hit Count range increased to a max of 120, up from the previous max of 20 11. Web Terminal was added Obtaining Firmware Updates: The most recent updates for our Console Server, Switched PDU and Data Fallback products can be found by visiting https://www.wti.com/pages/software For older firmware updates, please contact WTI Tech Support at service@wti.com, call our toll free service line at 1-888-280-7227, live chat or fill out a software request form at https://www.wti.com/pages/software Customer Service Department hours are 8 AM through 5 PM, Pacific Daylight Time. Installation: WTI Centralized Management Software (WMU), is the preferred method for installing firmware updates on WTI devices. The WMU software allows you to manage firmware updates for multiple WTI units from a single interface. For a description of the process for managing firmware updates via the WMU, please refer to the WMU user's guide, which can be downloaded from the WTI User's Guide Archive at: https://www.wti.com/pages/manuals-documentation Note that in order to use the WMU software, the existing firmware version for the WTI Device(s) must conform to the following standards: • Console Server Products (DSM, CPM, REM, TSM and RSM Series): Firmware Version v6.23 or higher. • Switched PDU Products (VMR, NBB, NPS, RPC and CCM Series): Firmware Version 1.48 or higher. • Data Fallback Switch Products (AFS Series): Firmware Version 2.30 When upgrading older units that are running firmware versions that are earlier than the standards listed above, it is recommended to use the WTI Firmware Upgrade Utility. A zip file that contains the installation files and other documentation for the WTI Firmware Upgrade Utility can be downloaded from WTI's FTP server, located at: https://ftp.wti.com/pub/TechSupport/Firmware/Upgrade_Utility/ Please refer to the documentation included in the zip file for further instructions. In addition to the WMU and WTI Firmware Upgrade Utility, the /UF command can also be used to install firmware upgrades. For more information on the /UF command, please refer to the user’s guide for your WTI device.